roofing starter strip application

Tuesday, November 8, 2022 Edit

Trim material from the end of the first. For such applications.

Asphalt Shingle Starter Strips Installation Guide To Improve Roof Shingle Wind Resistance

Before installing shingles on a roof you first have to install starter strip or starter shingles across the roofs perimeter.

. The starter strip is used to fill in the gaps created by shingle cutouts and joints. Weve installed thousands of complete roofing systems that include these essential starter strips. Cut 35 off from the first bottom starter piece.

Starter Strip Shingle APPLICATION INSTRUCTIONS First Starter Course. Starter strip remove the tab portion of each shingle and position the remaining strip with the factory-applied adhesive face up along the eaves. On the rake gable edges of the roof starter has 2 functions.

Drive a roofing nail through the flat portion of the shingle at the top and install a single row around the entire roof. Apply full-length IKO Leading Edge Plus starter strips to the remaining eave and rake edges of the roof deck. Begin by separating the strip at the perforated line.

But dont take our word for it check out what our many enthusiastic customers. The starter strip should be in line with the roof edge. Between ¼ and ¾ from the roof is a good length.

Installation of Starter Strip Plus shingle Starter Strip Plus shingle is designed to be separated into two pieces and each piece has its own sealant strip. Simply put it should not stick out too far from the edge of the roof. First to provide a nice straight line to cut shingles on.

Starter Course Left Rake Application. 4 followed by a full 13 38 x 40 starter. Fasten the remaining 5 x 13 38 to the deck as shown in Fig.

For example if youve chosen IKOs Armourshake shingles you should use IKO Armour Starter along with either IKOs EdgeSeal starter roll or our standard Leading Edge Plus. When separated each starter. To protect your home exterior Double D Construction installs 5- and 6-inch seamless gutters that.

Use galvanized zinc coated roofing nails 11 or 12 gauge with at least 38 diameter heads long enough to penetrate through plywood or 34 into boards. Starter shingles shall be nailed along a line not greater than 4 in. Install the starter strips granule side up with the factory applied sealant.

In this video I will go over. Starter Strip shingle with 6 removed Drip edge Self-adhered WeatherLock underlayment 393 8 65 8 3 4 Application Instructions Owens Corning Starter Strip can be used with any. This will give you a nice straight edge when looking up at the roof from the.

Above the eave line nailing not greater than 6 in. Begin the starter strip by cutting the strip half a tab short so that its joints will not line up with the joints of the first course of shingles. The starter strip should.

Attach with nails along the top edge of the strip. When applying shingles with exposures greater than 6 inches such as the Camelot collection only. Ensure that the cutouts of the first course are not placed over the starter.

Install GAF WeatherBlocker Starter Strip Shingles see Figure 1.

Installing Composition Shingles